QUATTRO 45mm SNAPSEAM
Steelformers Quattro 45mm Snapseam is one of the most cost effective architectural profiles available and is our only clip fixed profile that doesn't require an additional plywood substrate*. This customisable profile allows the user to alter the tray width to suit their design requirements and the ability to have to roll formed on site makes it logistical for those larger scale projects
*when used in roofing applications, excl. very high, extra high and SED wind zones
Suitable for residential, light commercial and commercial roofing and cladding applications
Sheet lengths are custom run to order. Sheet length restrictions may apply depending on project location
SCOPE OF USE
0.55mm (G300) BMT Colorsteel® Endura® and Maxx®, 0.75mm BMT Copper, 0.90mm BMT Mill Finish Aluminium and Colorcote® AlumiGard™ (conditions apply)
Contact your nearest branch for lead times
AVAILABLE IN A RANGE OF MATERIALS
The standard pan widths (from rib to rib) are 370mm and 460mm. Pans are variable on request
It is standard practice to run the pans with swages for extra rigidity and strength
PANS & SWAGES
Contact a Steelformers representative at your local branch for detailed technical advice.
A full range of flashing details are available for download by following the link above
TECHNICAL SUPPORT
SPECIFICATIONS
ROOFING APPLICATIONS
Quattro 45mm Snapseam with pan widths of up to 460mm can be installed over purlin supports in Low, Medium and High wind zones. In Very High, Extra High and SED (specific engineering design) wind zones, Quattro 45mm Snapseam must always be installed over a solid ply substrate with purlin supports*.
*Use of 45mm Snapseam in Extra High or SED wind zones (or areas that may experience these conditions) are subject to review by a Steelformers representative.
For more detailed information on the fixing of Quattro 45mm Snapseam in roofing applications, download our factsheet.
LOW TO HIGH WIND ZONE
Maximum 450mm purlin centres
(no ply substrate required)
Clips fixed at 450mm centres
.jpg)
VERY HIGH/EXTRA HIGH WIND ZONE
Maximum 450mm purlin centres (with min. 12mm ply substrate)
Clips fixed at 450mm centres
.jpg)
WALL CLADDING APPLICATIONS
Quattro 45mm Snapseam cladding is installed over a solid cavity system (make reference to Acceptable Solution E2 and the New Zealand Building Code for cavity requirements). In unlined areas, a cavity system is not required. Steelformers recommends nog spacing at 450mm centres in all wind zones, plus having a row of fixings along the line of the top and bottom of the cladding panels. Depending on the eaves construction, a row of nogs may be required at the soffit line.